Looking for a lower-cost alternative for your Clodbuster rear steer lockout? These 3d printed lockouts eliminate the need for any rear steering/lockout links at all! This design spreads the load across the axle C and inner knuckle surface, eliminating the chance of breaking the arm off of the steering knuckle. In fact, you can remove the arm completely for that ultra-clean look! These also allow both upper and lower 4-link mounting points to be used without interference.
Note: Rear tie-rod available separately which provides additional protection for your axle tubes on hard landings.
Shipping Charges: Our standard shipping charge is $5.50 for the 1st item and $1 for each additional item purchased.
(Shown above with optional tie-rod - available separately)